Bike Shield keeps your bike in mint condition by protecting it from scratches, grit and stones. It offers clear advantages over other products which aim to provide invisible protection for bike frames.
Bike Shield Frame Protection Stickers Features:
Ultra tough protection.
Self healing when cut. Easy to apply/remove by hand.
Leaves no sticky residue.
Invisible on the bike.
Will not yellow with age.
Half Pack - 4 Piece Set:
1 Tube Shield - 10 x 50cm.
1 Stay Shield.
2 Cable Shields - 2 x 3cm.
Buy Bike Shield Frame Protection Stickers from Chain Reaction Cycles, the world's largest online bicycle store.
Rated 5 out of 5 by Anonymous Going on all my future frames
perfect protection, very thick yet very applieable and very sticking , besure to clean the frame off and not touch the sticking side at all ( to leave no finger prints ) when applying. With a good pair of sissors/pen i measured and in some cases traced templates and managed to cover the top side of top tube, under side of down tube, rear of seat tube, covered around bottom bracket and used the chain stay sheild on the left hand chain stay ( i use a neoprean one on right hand side) admittedly my bike is a hard tail and i did have to piece the down tube guard but i took my time and all came out real nice with enough left over to cut patches for under cable routeing to.
11 November 2011
Rated 5 out of 5 by Anonymous very good
excelente film, boa aderencia e facil aplicacao
27 May 2011
Rated 5 out of 5 by Anonymous It does the job
Very good product. Easy to apply. Protects adequately from scratches.
08 April 2010
Rated 4 out of 5 by Anonymous Expensive but high quality product
Excellent frame protection, barley visible when carefully applied. Ensure frame is spotless prior to application (meths is effective) for a long lasting adhesion. Avoid finishing an edge on a tight radius as edges can lift and once unstuck, will never re-stick which generally means removing the whole section.
05 February 2010
Rated 5 out of 5 by Anonymous muy buen articulo
Buena calidad y durabilidad. Se adapta muy bien
04 September 2009
Rated 5 out of 5 by Anonymous Perfecto se adapata a cualquier forma del cuadro. Recomendable
06 August 2009
Rated 4 out of 5 by Anonymous Excellent - but not enough.
Used this on seven bikes so far!
Its quite thick and protects really well. When you take it off ie to sell the bike, theres no residue - it just peels of easily. Doesn't get five stars from they dont quite give you enough. To cover the down tube and top tube buy one and a half packs.
Spend a little time to do the job carefully. Clean the frame with white spirit, get some paper and make a template of the area you want to cover, then use this to cut the frameguard to shape. Apply from the middle of the tube working your way down so its stuck just in the middle. Now smooth it out a bit at a time to the outer edges so theres no air bubbles get trapped. If the top tube varies in shape you may need nick the plastic as it doesn't stretch much - or do the tubes in two halfs.
26 June 2009
Rated 3 out of 5 by Anonymous Used several times
Used this product under the "Extra" packaging on several bikes. Have to agree that a full pack is misleading, you could not cover the main tubes as most bikes have oversized tubes these days and you could use two packs just to cover the downtube. Get a couple of the half packs instead. As for applying, it takes some skill and is easier when used with a hairdryer on the curved tubes. You need a very sharp knife to score any areas that need to be removed, then you can peel the excess. The upside is it takes alot of abuse and will protect your frame from some serious damage. Summary the product works well, but if you are not good at craft type things then you will make a pigs ear of it, and there is never enough in a pack to cover what you want to.
19 October 2008