Fiber Grip™ is specially designed to create friction and reduce slippage between clamped carbon fiber surfaces. Fiber Grip eliminates the need to over tighten clamps to achieve secure connections. Over tightening can cause internal fractures and fatigue of carbon fiber parts. Apply Fiber Grip in a thin film to clamping areas of stems, handlebars, seat posts, and seat tubes. Tested and approved by leading carbon fiber component manufacturers.
Safety, Health and The Environment:
Finish Line’s Fiber Grip features an Inherently Biodegradable formulation which means that between 20% and 60% of the product will degrade within 28 days of being exposed to the outside environment.
Fiber Grip is non-toxic when used in quantities and applications as intended and contains no carcinogenic or hazardous air polluting (HAP) ingredients. Additionally, this product emits no Volatile Organic Compounds (VOCs).
Fiber Grip is REACH compliant for Europe and all ingredients used are listed with all major worldwide chemical inventories which means that this product, like all Finish Line Products, conforms to all environmental regulations for use as intended.
Fiber Grip contains no artificial dyes or fragrances, is non-flammable and is packaged in recyclable plastic tubes and tubs.
Rated 5 out of 5 by Anonymous Perfect for carbon
Exactly what you need when running carbon on carbon, apply a small amount, tighten to the correct spec and you don't need to worry.
13 December 2011
Rated 4 out of 5 by Anonymous Takes the stress out of installing carbon components
Bought this as carbon seatpin kept on slipping down, despite the bolt being torqued up correctly- too nervous to tighten it more than specified. Light smear of Fiber Grip and I haven't had to adjust again. It looks like the granules in some hand cleansers they must 'grip' the resin of the carbon and reduce the torque needed to get the right amount of friction.
I have also used it for handle bars. Recommended despite the relatively high price - 5 g would be more than enough for a complete carbon fibre bike build.
10 April 2010
Rated 5 out of 5 by Anonymous It works as it should!
Got this for my Easton Monkey bar an it did the job. Used it for brakehandles, stem and grips. Everything stays in place and the job was one in no time.
08 April 2010