The World's Largest Online Bike Store
  • NC-17 Big D S-Pro DH Bar 2014
  • NC-17 Big D S-Pro DH Bar 2014
From $52.99 - $56.49
  • RRP$77.49
  • |
  • SAVE UP TO 32%

Select  Colour
Select  Diameter
Select  Handlebar Rise
Select  Width
  • IN STOCK(5+)

  • right This item ships to United States of America
  • right Shipping amount : $9.99
  • right 365 DAYS to return or exchange
  • right Pay by Bank Transfer or PayPal or Card

NC-17 318MR-S Pro Handlebar

stiffness to weight to price! Nice flat and wide. No! Very broadly, the new 31.8 ter NC-17 handlebars. Polished and 20mm high it comes smoothly around the corner. At this point, the manufacturer can show what they can do. Because has at arms' stiffness to weight to price "a very special meaning, whose responsibility is NC-17 is more than aware and always was. So ultimately pays off trust. Thank you.


  • Material: 2014-T6 aircraft aluminum
  • Position markings
  • Identification number
  • Sweep: 5 °
  • Back Sweep: 7 °
  • Height: 20mm
  • Width: 785mm
  • Weight: 334g
  • Handlebar clamp: 31.8mm
  • anodized
  • laser engraved

Buy NC-17 318MR-S Pro Handlebar from Chain Reaction Cycles, the World’s Largest Online Bike Store.

  • Colour: Blue, Red, Gold, Polished Silver, Black
  • Material: Alloy
  • Width: 785mm
  • Diameter: 31.8mm
  • Handlebar Rise: 20mm
Rated 4 out of 5 by 2 reviewers.
Rated 4 out of 5 by Good bar. Tough. Not too much vibration. Not to much deflection. I made the mistake of cutting mine a bit short so might end up buying another one day. 28 September 2014
Rated 4 out of 5 by light, strong and look legit! put these on my bike about 2 weeks ago now, and so far i cant fault them, as for the feel, they are like most other bars on the market due to the stereotypical 5/9 degree sweep. they are very light for the width of the bar and the ano black finnish seems strong and doesnt scratch easily. the only problem i could see is if you were to cut them down, it will be a bit of a squeeze to get your grip, shifter and lever on the bar (if you run your levers far away from the grip) but i am not cutting them so they are fine. 15 November 2010
1-2 of 2