Rated 3 out of 5 by clockworked bolts that fit
fit fine. do as they say they will. still a little over priced
17 December 2013
Rated 4 out of 5 by Anonymous Good
Use a quality hex tool and they hold up much better. If bolts are too tight put a vise on the clamp to relieve the presure, then bolts are easier to remove. Don't use too much presure from the vise, use an old inner tube to protect the clamp from getting marked. (Don't use this techinique for carbon bars)
10 July 2010
Rated 3 out of 5 by Anonymous Will these fit NC-17 clamps??
Have rounded mine off, if I manage to get them off I am going to need new bolts. Anyone know if these will fit?
04 June 2009
Rated 3 out of 5 by Anonymous If you can get the size right, buy some gold Ti ones from ProBolt. Lighter and wont round off. Plus, they're in gold. BLIIING!!!
12 March 2009
Rated 2 out of 5 by Anonymous bolts
rounded of after one removel twisted grip grip broke of the clamp had to hacksaw of bars damaging the bars in the process therfore needing to buy new bars aswell as grips not good keep clear bag of s---
12 January 2008
Rated 2 out of 5 by Anonymous quite rubbish really
ok, yes they hold your grip in place which means no grips spinning on your bars . . . . . but when i wanted to take mine off, one of the bolts had rounded off so much that i had to use a jigsaw to cut it off !!!!!!
poor quality bolts!!
21 October 2007
Rated 4 out of 5 by Anonymous good replacement
These bolts from crc do fit which is a good thing, but really they shouldnt round off in the first place... at least you can buy replacements though!
30 April 2007
Rated 3 out of 5 by Anonymous Cheese
Thats what these are made of, tighten carefully!
24 April 2007